RailClone > RailClone Pro (*)

scalloped profiles

(1/2) > >>

KD4391:
hi guys

i need to do this scalloped profile underneath the kitchen benchtops and these benchtops are also curved - is it possible to set up a railclone for this while retaining proportions around the curved areas?
a couple of examples below.
https://www.skheme.com/media/10055/colombian_2.jpg
https://marbleceramiccorp.com.au/stone-mosaic-capping-tiles/5315-carrara-concave-honed-marble-mosaic.html?gclid=Cj0KCQiA-JacBhC0ARIsAIxybyNaJTKJLs6yZZCejjs3tYsV982TPeODO-nofPc43OQWE67MTIsiAgwaAoJOEALw_wcB

many thanks
Simon

Paul Roberts:
Hi,

That should be fine, just wire the scallops to the Generator's Default input and make sure that you turn off Deform > Bend in the Segment Node's settings so that they don't deform to follow the curve.

Best,

Paul

KD4391:
Thanks Paul - however it doesnt really connect on the edges.

See attached.

Paul Roberts:
Please try changing the Y Alignment for the Segment to Top. the issue at the moment is that it is aligning using the center of the geometry.

I hope that helps,

Paul

KD4391:
Thanks Paul but its still not working for me?   see attached.  I also tried changing the pivot of the base object - couldnt get it to work - its overlapping.
Any chance you can do it and send the scene here so i can study what you did?

Navigation

[0] Message Index

[#] Next page