RailClone > RailClone Pro (*)
scalloped profiles
KD4391:
hi guys
i need to do this scalloped profile underneath the kitchen benchtops and these benchtops are also curved - is it possible to set up a railclone for this while retaining proportions around the curved areas?
a couple of examples below.
https://www.skheme.com/media/10055/colombian_2.jpg
https://marbleceramiccorp.com.au/stone-mosaic-capping-tiles/5315-carrara-concave-honed-marble-mosaic.html?gclid=Cj0KCQiA-JacBhC0ARIsAIxybyNaJTKJLs6yZZCejjs3tYsV982TPeODO-nofPc43OQWE67MTIsiAgwaAoJOEALw_wcB
many thanks
Simon
Paul Roberts:
Hi,
That should be fine, just wire the scallops to the Generator's Default input and make sure that you turn off Deform > Bend in the Segment Node's settings so that they don't deform to follow the curve.
Best,
Paul
KD4391:
Thanks Paul - however it doesnt really connect on the edges.
See attached.
Paul Roberts:
Please try changing the Y Alignment for the Segment to Top. the issue at the moment is that it is aligning using the center of the geometry.
I hope that helps,
Paul
KD4391:
Thanks Paul but its still not working for me? see attached. I also tried changing the pivot of the base object - couldnt get it to work - its overlapping.
Any chance you can do it and send the scene here so i can study what you did?
Navigation
[0] Message Index
[#] Next page
Go to full version