Itoo Software Forum

RailClone => RailClone Pro (*) => Topic started by: HB2523 on October 09, 2017, 06:26:46 PM

Title: Segments not being sliced across edges
Post by: HB2523 on October 09, 2017, 06:26:46 PM
I've made a simple box and a closed spline with some Corners and Beziere corners. The Segment node with the box is set to both Bend and Slice but the slicing doesn't work propperly. It doesn't slice across the whole model but leaves edges intact that results in intersecting polygons. See the attached image. How can I fix this to get a better connections between the segments?
Title: Re: Segments not being sliced across edges
Post by: Michal KarmazĂ­n on October 10, 2017, 12:01:47 PM
Hi,

You can adjust how Corners are handled under Generator's Rules > Corner > Bevel Mode / Bevel Corner etc. Also, the Alignment settings for used Segment will have influence over the final result. Hope that helps.

Best regards,