Itoo Software Forum

RailClone => RailClone Pro (*) => Topic started by: Victor Vlasenko on November 01, 2023, 05:31:10 pm

Title: Sequence reset at spline section doesn't work
Post by: Victor Vlasenko on November 01, 2023, 05:31:10 pm

Hi,
2 segments in sequence and if I select reset at the spline section - only the first connected segment is displayed, the rest is ignored. Same for conditional - position on spline works, on spline section - no.
Or maybe I'm doing something wrong?

Sequence connected to evenly between corners and start/end.
Latest railclone

Title: Re: Sequence reset at spline section doesn't work
Post by: Michal Karmazín on November 02, 2023, 09:34:50 am

Hi Victor,

That's because of using the Evenly input (you may consider using the Default one). Currently, Evenly segments divide the spline into sections, so this sequence mode makes little sense for them - in terms of spline section corners and even division, both split up the spline. We'll see what can be done in future versions.

I hope that clarifies it.

Best regards,