ITOOSOFT Forum

RailClone => RailClone Pro (*) => Topic started by: Ricousto on September 25, 2025, 04:38:59 pm

Title: Sequencing ID
Post by: Ricousto on September 25, 2025, 04:38:59 pm

Hello

Another beginner's question:
I am trying to sequence identification materials on a simple L1S network driven by a spline path, as in the example below -> ID 2 / ID 1 / ID 1 / ID 1 / ID 1 / ID 2 / ID 1....
I've tried, but I can't figure it out.
Can you please help me understand?

Thanks in advance.

Title: Re: Sequencing ID
Post by: Michal Karmazín on September 26, 2025, 09:05:36 am

Hi,

For these purposes, you can use the Sequence Operator (https://docs.itoosoft.com/railclone/style-editor/operators/sequence), which lets you easily adjust counters for the corresponding segments as needed. Please find attached a sample scene that demonstrates a possible style setup. I hope this helps.

Best regards,

Title: Re: Sequencing ID
Post by: Ricousto on September 26, 2025, 03:47:01 pm

I found another way to do it, but your solution is so much smarter   :o
Thank you !