Itoo Software Forum

Author Topic: switching geometry as parameter?  (Read 443 times)

lukx

  • Full Member
  • ***
  • Posts: 167
    • lukxCGI
switching geometry as parameter?
« on: September 15, 2020, 01:15:09 PM »
Sorry if it's stupid question, but I can't figure it out. Is is possible to switch geometry as Parameter?
1 is box, 2 is sphere etc? Is it possible to setups something like this in RC?

Dragan

  • Hero Member
  • *****
  • Posts: 1419
Re: switching geometry as parameter?
« Reply #1 on: September 15, 2020, 01:24:28 PM »
Hi
Yes, You can >> Selector Operator.
You can export the Index Parameter and connect the Numeric node to expose it in General Parameter Rollout.

lukx

  • Full Member
  • ***
  • Posts: 167
    • lukxCGI
Re: switching geometry as parameter?
« Reply #2 on: September 15, 2020, 05:15:21 PM »
awesome, thank you!