Itoo Software Forum
RailClone => RailClone Pro (*) => Topic started by: IT1371 on September 04, 2019, 03:27:51 PM
-
I have to make this kind of pattern. The brick sizes are 2:1.
So far I usually used a different linear generator for such things, but the area I need to cover now is huge and will take hours for this.
I understand I should be using an 2S generator for this, but I don't know how to make the offset right.
(https://i.imgur.com/5NQwSGA.jpg)
-
Hi
I attach You my setup.
(https://i.imgur.com/qmq9ZF1.png)
I would recommend You reading this thread (https://forum.itoosoft.com/railclone-pro-(*)/pattern/) about patterns.
-
Thank you so much!
I will sure take a look into it.