RailClone > RailClone Pro (*)

Sleeper Retining Walls

(1/3) > >>

PX2937:
I'm planning on making a retaining wall railclone, in the same way i saw a brick wall be made in this forum a while ago with arrays by staggering this bricks and using macros if im not mistaken and to have the sleepers interlock on corners. Im not very familiar with arrays/macros and would just like to ask for any pointers on how would be the most efficient way to achieve this? Ideally id like to be able to add a parameter to set the number of vertical sleepers. Ill attach an example image, thanks!

Michal Karmazín:
Hi,

Feel free to use the bundled Bricks - Running Bond macro (Macros > Generators > Bricks and Walls > Bricks - Running Bond), which should achieve the desired result.

Best regards,

PX2937:
Thanks ill have a look into this, never used these macros before, so ill probably be back!

PX2937:
So I've made a start by using a brick wall example which I found on this forum a while back, I've managed to make a decent start on this, however I cant figure out why the segments are overlapping/stretching when the spline goes in the other direction, some of my areas on site only extend say 600mm at a 90 degree angle from the main length, ill attach a screenshot and a stripped down scene file, the green line suggests where I'd like the railclone to end, and the red just shows the clipping/extended segments, any help would really be appreciated!

PX2937:
Hey, just a follow up, any ideas on how to could fix this issue im having above? Thanks!

Navigation

[0] Message Index

[#] Next page