sloped brick wall

[BJ2494]

I need help with this:
I wanted to make a brick wall with spaces between them and with an inclination as it goes up in height
Thanks and sorry for the translation

[Dragan]

Hi,
I had a macro for this but can`t find it now  !
Give me a few minutes to build a new one.

[Dragan]

Hi
Here is the Macro. My math for Vertical Adaptive+Vertical Gap is not correct at the moment but I don`t have time to solve this right now 

Macro can work in 3 modes:
1. With the Wall Heigth parameter (Y Spline not assign).
2. With X/Y Spline (Y Spline is assigned and it controls height)
3. Clipping Spline > When Clipping Spline is assigned and `Use Clipping.Ext.Size`check box is ON. (If the Check box is OFF Clipping Spline will act  as ordinary clipping for the first two modes)

note; You can get some interesting results by exposing parameters and adding some Random/Arithmetic Nodes.
eg. I exposed the Z offset parameter and connect the Random Node set with values -3 to 3 and generate on SEGMENT. This will result in randomness for each brick...
Please let me know if you need more info about the parameters.
Best Regards

[BJ2494]

Please MAX 2019
Thank you

[Dragan]

I`m using MAx2018.It should work on Max2109.

[BJ2494]

sorry, Max 2017

[Dragan]

Sure.

[BJ2494]

thank you very much, great job