Itoo Software Forum
RailClone => RailClone Pro (*) => Topic started by: BJ2494 on November 16, 2020, 05:48:25 PM
-
I need help with this:
I wanted to make a brick wall with spaces between them and with an inclination as it goes up in height
Thanks and sorry for the translation(http://)
-
Hi,
I had a macro for this but can`t find it now :o !
Give me a few minutes to build a new one.
-
Hi
Here is the Macro. My math for Vertical Adaptive+Vertical Gap is not correct at the moment but I don`t have time to solve this right now :(
Macro can work in 3 modes:
1. With the Wall Heigth parameter (Y Spline not assign).
2. With X/Y Spline (Y Spline is assigned and it controls height)
3. Clipping Spline > When Clipping Spline is assigned and `Use Clipping.Ext.Size`check box is ON. (If the Check box is OFF Clipping Spline will act as ordinary clipping for the first two modes)
note; You can get some interesting results by exposing parameters and adding some Random/Arithmetic Nodes.
eg. I exposed the Z offset parameter and connect the Random Node set with values -3 to 3 and generate on SEGMENT. This will result in randomness for each brick...
Please let me know if you need more info about the parameters.
Best Regards
-
Please MAX 2019
Thank you
-
I`m using MAx2018.It should work on Max2109.
-
sorry, Max 2017
-
Sure.
-
thank you very much, great job :)