Itoo Software Forum

Author Topic: Spider Glazing tutorial  (Read 539 times)

LH2287

  • Newbie
  • *
  • Posts: 7
Spider Glazing tutorial
« on: December 13, 2017, 02:44:35 PM »
Hello,

I am trying to use the Spider glazing tutorial files and modify them for my project. I want to extend the Xspline in order to have a longer facade, but it builds only to a certain point and stops after that, almost like something is limiting the X length of the facade. The Yspline length is working properly and the facade can be extended as desired. Is there any solution to this? I am using RC 3.0.9.

Thanks

Best regards

Michal Karmazín

  • iToo Software
  • Hero Member
  • *****
  • Posts: 1535
Re: Spider Glazing tutorial
« Reply #1 on: December 13, 2017, 04:38:49 PM »
Hi,

It sounds like, that such spline is being "limited" by the Base Objects > Properties > Start or Lenght value - enabling the Full Lenght option should fix it. Attaching screen-shot. Hope that helps.

Best regards,

LH2287

  • Newbie
  • *
  • Posts: 7
Re: Spider Glazing tutorial
« Reply #2 on: December 13, 2017, 05:03:24 PM »
Thanks a lot. It seems there is always an option that is hiding somewhere. Worked perfectly. 

Best regards