Itoo Software Forum

RailClone => RailClone Pro (*) => Topic started by: EI3056 on February 25, 2020, 10:07:52 AM

Title: Spiral Staircase
Post by: EI3056 on February 25, 2020, 10:07:52 AM
Hey,

I tried to make a half-spiral staircase in RailClone, but always end up with some issues.
I´ve adjusted the RailClone object from this file: https://forum.itoosoft.com/railclone-pro-(*)/spiral-staircase/msg6915/#msg6915 (https://forum.itoosoft.com/railclone-pro-(*)/spiral-staircase/msg6915/#msg6915)

The "inner" side of the stairs looks good and every step has the same depth.
The "outer" side looks weird. I´ve attached a screenshot and the RC File.

Any idea how I can fix this issue?
Thanks!

Title: Re: Spiral Staircase
Post by: Rokas on February 25, 2020, 02:44:00 PM
Hi

To fix Helix shapes for RailClone, You should do the following:

Set Spline Segment type to Curve
Set Vertex Type to Smooth

(https://i.imgur.com/fs5HfLU.gif)

Hope this helps.
Title: Re: Spiral Staircase
Post by: EI3056 on February 26, 2020, 10:48:42 AM
Hey Rokas

Thanks for the reply, that´s an easy fix.