Itoo Software Forum

RailClone => RailClone Pro (*) => Topic started by: IS4550 on July 03, 2019, 01:59:12 PM

Title: spline Mtl ID problem
Post by: IS4550 on July 03, 2019, 01:59:12 PM
I want to make a default stone curb with IDs 1 and 2*.
And when I change my spline Mtl ID to 2, curbe doesn't follow the spline? Did anyone had similar problems?
Thank you
 
Title: Re: spline Mtl ID problem
Post by: Rokas on July 03, 2019, 03:08:18 PM
Hi. Welcome to the forum.
We can take a look in Your situation only if You attached or shared (https://forum.itoosoft.com/faq/how-to-send-a-file-to-itoo-software) Your files.
Title: Re: spline Mtl ID problem
Post by: IS4550 on July 03, 2019, 03:21:08 PM
Thank you, I have placed the max file in the attachment :)
Title: Re: spline Mtl ID problem
Post by: Rokas on July 04, 2019, 10:16:18 AM
Hi

That's a limitation of using material IDs.
RailClone splits the spline so curves that bridge IDs are no longer a continuous smooth sweep.

You can check workarounds for this issue in this thread (https://forum.itoosoft.com/railclone-pro-(*)/railclone-drop-curb-issue-on-curved-spline/msg14852/#msg14852)
Title: Re: spline Mtl ID problem
Post by: IS4550 on July 04, 2019, 11:49:33 AM
Thank you very much for the response, it is much appreciated. :)