Itoo Software Forum

RailClone => RailClone Pro (*) => Topic started by: antmx on August 08, 2019, 12:35:48 PM

Title: Stopping an END or START segment at spline ID change
Post by: antmx on August 08, 2019, 12:35:48 PM
I have a style with an end and start segment, but now I want to change my spline ID to make a different style on the same spline, but the end segment is in the way.  Hopefully the image below describes it. 

I can use a conditional operator and change each spline section to curve or line and wire in a null segment, but this isn't really what I want as a solution.

Is there an elegant or simple way around this.


(https://i.ibb.co/1KHK4NM/spline-ID-and-segments-at-the-junction.jpg)
Title: Re: Stopping an END or START segment at spline ID change
Post by: Rokas on August 08, 2019, 01:32:55 PM
I can use a conditional operator and change each spline section to curve or line and wire in a null segment, but this isn't really what I want as a solution.

That seems like a reasonable solution. When using limit to Material ID, imagine different Material ID as separate splines.