Itoo Software Forum

Author Topic: strange gaps  (Read 9334 times)

info@3deek.nl

  • Newbie
  • *
  • Posts: 20
strange gaps
« on: June 17, 2013, 12:45:06 PM »
why is my railclone object leaving this strange gaps?

iToo

  • Administrator
  • Hero Member
  • *****
  • Posts: 4388
    • iToo Software
Re: strange gaps
« Reply #1 on: June 17, 2013, 01:03:47 PM »
Because the height of each row is adjusted to the largest segment (on Y) used on that row.

As far i can see, the gap is generated in the Y Evenly row: so just use the Top/Bottom paddings (of the evenly segment), to adjust the separation.

Carlos Quintero
iToo Software