Itoo Software Forum

RailClone => RailClone Pro (*) => Topic started by: lukx on September 15, 2020, 01:15:09 PM

Title: switching geometry as parameter?
Post by: lukx on September 15, 2020, 01:15:09 PM

Sorry if it's stupid question, but I can't figure it out. Is is possible to switch geometry as Parameter?
1 is box, 2 is sphere etc? Is it possible to setups something like this in RC?

Title: Re: switching geometry as parameter?
Post by: Dragan on September 15, 2020, 01:24:28 PM

Hi
Yes, You can >> Selector Operator.
You can export the Index Parameter and connect the Numeric node to expose it in General Parameter Rollout.

Title: Re: switching geometry as parameter?
Post by: lukx on September 15, 2020, 05:15:21 PM

awesome, thank you!