Itoo Software Forum

Author Topic: ID spline selection for Mirror  (Read 1005 times)

antmarch

  • Newbie
  • *
  • Posts: 34
    • portfolio
ID spline selection for Mirror
« on: December 14, 2016, 02:01:39 PM »
Is there a way to output the mirror option to a linear array, and create a conditional selection based on spline ID?

For instance, I want ID 1 & 2 to use the mirror option, (double balustrade either side of a gantry) and ID 3 to only use the offset (a single balustrade on one side )

I have numerous linear arrays dependant on the mirror feature, and would rather not copy all these and have to set the ID channels accordingly.





« Last Edit: December 14, 2016, 02:11:45 PM by antmarch »

Michal Karmazín

  • iToo Software
  • Hero Member
  • *****
  • Posts: 2447
Re: ID spline selection for Mirror
« Reply #1 on: December 14, 2016, 04:18:33 PM »
Hi,

It's not possible to assign different boolean values for the Mirror option upon the Material ID within one Generator, but it's possible to have multiple similar Generators (with / without the Mirror option selected) driven by base spline segment's Material ID (with Equal, Not, Greater, Less options).

Hope that helps.

Best regadrs,

antmarch

  • Newbie
  • *
  • Posts: 34
    • portfolio
Re: ID spline selection for Mirror
« Reply #2 on: December 15, 2016, 04:06:18 PM »
yes thats what I was hoping to avoid.  thanks Michal.