Itoo Software Forum

RailClone => RailClone Pro (*) => Topic started by: arch3d on August 26, 2022, 11:03:00 AM

Title: Vertical Top/Bottom negatice values
Post by: arch3d on August 26, 2022, 11:03:00 AM
Would be nice if I could type negative values for vertical top/bottom (segments placed below spline). Now only solution which i found is do it as style "above" spline and move whole generator

Best
Michal
Title: Re: Vertical Top/Bottom negatice values
Post by: Paul Roberts on August 26, 2022, 11:09:57 AM
I agree! It can be an issue when the geometry is below the spline. I'll pass your suggestions on to the development team.

Best,
Paul
Title: Re: Vertical Top/Bottom negatice values
Post by: arch3d on August 26, 2022, 11:31:14 AM
Thx
Title: Re: Vertical Top/Bottom negatice values
Post by: Dragan on August 26, 2022, 12:04:44 PM
+1