Itoo Software Forum

Author Topic: What condition covers this?  (Read 4343 times)


  • Full Member
  • ***
  • Posts: 122
What condition covers this?
« on: March 03, 2014, 07:50:10 AM »
Without manually changing id's or changing curves to lines, how do I have the red segment only apply to the round corners? I thought the vertex angle did it, but apparently not. Screenshot and file attached (max 2014). Note that this is just an example, and I can't cheat it by using segment length, because the real situation has corners of different radius.


  • Administrator
  • Hero Member
  • *****
  • Posts: 3932
    • iToo Software
Re: What condition covers this?
« Reply #1 on: March 03, 2014, 06:42:40 PM »
Really the "Angle" condition was designed to change the type of Segment in a Corner rule. It doesn't work with Default segments, because there is not any angle that we can use it for comparing.

I'll discuss it with my team, but i cannot see any condition (even implementing it) that we could use to solve this case.
Carlos Quintero
iToo Software