Itoo Software Forum

Author Topic: feature request: keep start/end in Scale mode  (Read 3001 times)

harumscarum

  • Full Member
  • ***
  • Posts: 113
    • harumscarum's portfolio
feature request: keep start/end in Scale mode
« on: December 25, 2014, 01:04:11 AM »
would be great to have an option keep start and end of segment of its original size in Scale and Count segment modes with certain threshold (like Flat Top/Bottom option for Vertical mode)
this will allow use only one segment for many different window sizes

P.S. Scale Mode work incorrectly (use Count=1 instead)
« Last Edit: December 25, 2014, 01:08:54 AM by harumscarum »

iToo

  • Administrator
  • Hero Member
  • *****
  • Posts: 4388
    • iToo Software
Re: feature request: keep start/end in Scale mode
« Reply #1 on: December 26, 2014, 11:28:33 AM »
Ok, added to the wishlist.

Please, would you upload a scene with the scale/count problem ? I cannot reproduce it here.
Thanks.
Carlos Quintero
iToo Software

harumscarum

  • Full Member
  • ***
  • Posts: 113
    • harumscarum's portfolio
Re: feature request: keep start/end in Scale mode
« Reply #2 on: December 26, 2014, 02:01:37 PM »
yes please here is file atached - it looks like that - http://joxi.ru/dp27G8tnadB27n

iToo

  • Administrator
  • Hero Member
  • *****
  • Posts: 4388
    • iToo Software
Re: feature request: keep start/end in Scale mode
« Reply #3 on: December 27, 2014, 11:33:32 AM »
Ok, i see what happens: when Bevel is enabled in Scale mode, the segment is extended beyond the corner to generate a correct chamfer. This correction is not applied using Count, because this mode is not compatible with bevels.

To fix it, just set Bevel mode to None (or use Count=1).
Carlos Quintero
iToo Software