Itoo Software Forum

Author Topic: why are ther coplanar planes in my railclone object?  (Read 1417 times)

info@3deek.nl

  • Newbie
  • *
  • Posts: 20
why are ther coplanar planes in my railclone object?
« on: December 04, 2013, 01:33:38 PM »
First of all, I really like Rail-clone. It the biggest time saver ever!
But off course there are some things I don't understand:
I constructed an escalator. I know I can also construct it with a 2d array but then it only works on a single spline, and I need a lot of them. So i build it with multiple 1d arrays in one railclone object. Everything, sort of, works. But I get coplanar planes in the curved section where the escalator bends down (or up), I don't understand why. Why isn't the geometry sliced?

Can someone help me out? Thanks in advance.

File attached

iToo

  • Administrator
  • Hero Member
  • *****
  • Posts: 3157
    • iToo Software
Re: why are ther coplanar planes in my railclone object?
« Reply #1 on: December 04, 2013, 03:27:34 PM »
As far as i can see, the overlapped faces are already in the segment's mesh. Please, would you check it ?
Carlos Quintero
iToo Software

info@3deek.nl

  • Newbie
  • *
  • Posts: 20
Re: why are ther coplanar planes in my railclone object?
« Reply #2 on: December 04, 2013, 04:03:31 PM »
I'm sorry, you're right! Thanks!