Itoo Software Forum

Author Topic: Wooden walkway bending on z-axis  (Read 369 times)

Terri Brown

  • Newbie
  • *
  • Posts: 40
Wooden walkway bending on z-axis
« on: April 24, 2017, 10:24:07 AM »
Hi guys,

I am sure there's a simple solution to this but I can't seem to figure it out. I have created a very simple wooden walkway out of a linear array with three boxes of varying widths. However instead of the path being flat and aligned on the z-axis it seems to deform and bend so would in reality be impossible to walk on.

Please advise. I'm sure there's just a simple checkbox I need to tick...just can't seem to find it!

Thanks a mil.

Terri Brown

  • Newbie
  • *
  • Posts: 40
Re: Wooden walkway bending on z-axis
« Reply #1 on: April 24, 2017, 10:27:19 AM »
Ok i'm an idiot...sorry. Checked the 'vertical' option under deform for each section.

Sorry! Total newbie here!