Itoo Software Forum

RailClone => RailClone Pro (*) => Topic started by: Terri Brown on April 24, 2017, 10:24:07 AM

Title: Wooden walkway bending on z-axis
Post by: Terri Brown on April 24, 2017, 10:24:07 AM
Hi guys,

I am sure there's a simple solution to this but I can't seem to figure it out. I have created a very simple wooden walkway out of a linear array with three boxes of varying widths. However instead of the path being flat and aligned on the z-axis it seems to deform and bend so would in reality be impossible to walk on.

Please advise. I'm sure there's just a simple checkbox I need to tick...just can't seem to find it!

Thanks a mil.
Title: Re: Wooden walkway bending on z-axis
Post by: Terri Brown on April 24, 2017, 10:27:19 AM
Ok i'm an idiot...sorry. Checked the 'vertical' option under deform for each section.

Sorry! Total newbie here!