Itoo Software Forum

Author Topic: translation perpendicular to spline ?  (Read 2912 times)

Ingo

  • Newbie
  • *
  • Posts: 7
translation perpendicular to spline ?
« on: May 13, 2013, 02:14:44 PM »
Hello,

when I´m using the y offset option in the geometry rollout, the segment moves in the direction of the red arrow in the screenshot. Is there a possibility to offset the segment perpendicular to the spline (like the blue arrow) ? 

Kind regards
Ingo


iToo

  • Administrator
  • Hero Member
  • *****
  • Posts: 3158
    • iToo Software
Re: translation perpendicular to spline ?
« Reply #1 on: May 13, 2013, 03:50:07 PM »

Are you using the Evenly rule ? If so, please check the Sync Offset parameter. It defines exactly this behaviour:

http://www.itoosoft.com/railclone/reference/refgeometry.php (just at the page's bottom).

Carlos Quintero
iToo Software

Ingo

  • Newbie
  • *
  • Posts: 7
Re: translation perpendicular to spline ?
« Reply #2 on: May 13, 2013, 04:13:13 PM »
Thanks, that was the button I was searching for...  Sorry for that, I´m am RailClone newbie.