translation perpendicular to spline ?

[Ingo]

Hello,

when I´m using the y offset option in the geometry rollout, the segment moves in the direction of the red arrow in the screenshot. Is there a possibility to offset the segment perpendicular to the spline (like the blue arrow) ? 

Kind regards
Ingo

[iToo]

Are you using the Evenly rule ? If so, please check the Sync Offset parameter. It defines exactly this behaviour:

http://www.itoosoft.com/railclone/reference/refgeometry.php (just at the page's bottom).

[Ingo]

Thanks, that was the button I was searching for...  Sorry for that, I´m am RailClone newbie.