Itoo Software Forum

RailClone => RailClone Pro (*) => RailClone Pro 1.x => Topic started by: Ingo on May 13, 2013, 02:14:44 PM

Title: translation perpendicular to spline ?
Post by: Ingo on May 13, 2013, 02:14:44 PM
Hello,

when I´m using the y offset option in the geometry rollout, the segment moves in the direction of the red arrow in the screenshot. Is there a possibility to offset the segment perpendicular to the spline (like the blue arrow) ? 

Kind regards
Ingo

Title: Re: translation perpendicular to spline ?
Post by: iToo on May 13, 2013, 03:50:07 PM

Are you using the Evenly rule ? If so, please check the Sync Offset parameter. It defines exactly this behaviour:

http://www.itoosoft.com/railclone/reference/refgeometry.php (http://www.itoosoft.com/railclone/reference/refgeometry.php) (just at the page's bottom).

Title: Re: translation perpendicular to spline ?
Post by: Ingo on May 13, 2013, 04:13:13 PM
Thanks, that was the button I was searching for...  Sorry for that, I´m am RailClone newbie.