RailClone > RailClone Pro Beta

RC Slice

(1/2) > >>

Dragan:
First of all - love it!
Not sure if this would be possible (I guess you already had this idea).
As it is now Segment Node has Modifier Output and Selections for Generator Input.
How about "Automatic" mode, so the Source would automatically match the Generator's Input that is connected?  ::)

iToo:
Yes, this was discussed while the development, but i could not find a clean way to implement it.

Segment geometry is prepared on an initial step, before the graph is evaluated. At this point it's not possible to know what slice will be required.
I though some weird workarounds, as storing all possible slices for each segment. But this is a bit complex, and not very efficient.

Dragan:
Yeah. I thought so.
There are still a lot of crashes and hangouts with RC Slice but I`m testing it, keeping track, and eventually giving you back the report.  ???
Regards
 

Dragan:
I'm very satisfied with the modifier as it is, real-time feedback is great and very easy to set up.
However, sometimes I'm missing to have a better view of slice positions (planes). When the mesh wire is complex sometimes is hard to distinguish where the cutting lines are.
So some check box for temporary showing slicing planes would be great (having some shortcut key would be even better).
I`m also missing the possibility of snapping since we don't have access to the slicing planes.

EI3056:
Not sure if I missed something here, but do we have to duplicate the segment node for each Generators input and select a different source?
If that´s the case, is there any way to make it more convenient to swap geometry and keeping the graph clean by getting all RC Slice sources from a single node?
Cheers

Navigation

[0] Message Index

[#] Next page