Itoo Software Forum

RailClone => RailClone Pro (*) => RailClone Pro Beta => Topic started by: Dragan on February 16, 2025, 02:42:10 pm

Title: Spline offset + Filter By Mat.ID
Post by: Dragan on February 16, 2025, 02:42:10 pm

Something wrong when nodes are set as:  Offset -> Filter
It seems to be working fine when nodes are set as: Filter -> Offset

Title: Re: Spline offset + Filter By Mat.ID
Post by: iToo on February 17, 2025, 10:07:55 am

Same case as Boolean. Offset operator generates new splines, altering Mat.ID in the process.
I will check if it's possible to improve that, at least with the '3D mode', which is less destructive.