Itoo Software Forum

Author Topic: Creating Kitchens with RailClone  (Read 33393 times)

Paul Roberts

  • iToo Software
  • Hero Member
  • *****
  • Posts: 2997
Creating Kitchens with RailClone
« on: June 30, 2016, 10:48:33 AM »
Please post any questions here about the "Creating Kitchens with RailClone" tutorial.
« Last Edit: July 01, 2016, 01:46:05 PM by Paul Roberts »
Paul Roberts
iToo Software

eqko

  • Jr. Member
  • **
  • Posts: 96
Re: Creating Kitchens with RailClone
« Reply #1 on: July 01, 2016, 11:26:42 AM »
I salute you good sir.

I was just thinking day before yesterday that RC would lend itself most excellent for a kitchen system  :)

Barry

  • Newbie
  • *
  • Posts: 7
Re: Creating Kitchens with RailClone
« Reply #2 on: July 01, 2016, 01:47:22 PM »
This is genius. I am so glad I discovered RailClone.

Bruno NM

  • Newbie
  • *
  • Posts: 30
Re: Creating Kitchens with RailClone
« Reply #3 on: February 05, 2018, 04:45:58 PM »
Hi everyone !
It's been a long time i have this question in mind, we spoke about kitchen, but in this tutorial, this is more a linear kitchen.
What about ''U'' and ''L'' shape kitchen ?
Could raiclone handle corners with the same flexibility we achieved in the kitchen tutorial ?

If you have some example, i will be very interesting to study it ;D


ASD+Viz

  • Newbie
  • *
  • Posts: 11
Re: Creating Kitchens with RailClone
« Reply #4 on: September 12, 2022, 05:32:42 AM »
Ok so finally after multiple failed attempts I finally got the hang of the Kitchen Cabinet Tutorial. I would like to say that I have designed several Modular kitchens so far, 5 to accurate :).
I have never been asked to show the panels over or under the side panels. What I would like is, how I can make sure that the front panels never get larger than 2 feet (In Width) and never less that 1 feet. Is there a way to do this without placing vertex points?? My current Kitchen cabinet design involves a linear 32 feet linear kitchen. Will share the progress soon. Also what should be the approach towards an Island?