Advice on how to build office ceiling with offset lighting

[matthewfloyd]

Hi,

I'm trying to build the ceiling below, it has a sequence of of 2 lines of lights, with every other line down the ceiling, being offset. Ive currently achieved something similar, but offsetting the second sequence by using translation, but it is not giving the nice edges around the spline, as they are always being offset by the amount of specified.

I wouldn't mind some advice on how you would go about building this?

Thanks!

[Michal Karmazín]

Hi,

It shouldn't be necessary to use translation. Instead, using a combination of Sequence Operators in the Increment at X and Increment at Y modes to alternate these in the Start/Bottom Input (depending on your style setup) should do the trick. I hope that helps.

Best regards,

[matthewfloyd]

hey mate, sorry im a little confused on this one, would it be possible if you could show me an example?