Itoo Software Forum

Author Topic: Fallof affect surface + paint area  (Read 180 times)

leonardo.afanador

  • Newbie
  • *
  • Posts: 34
Fallof affect surface + paint area
« on: December 20, 2018, 03:06:11 PM »
hi,
I`m creating a forest simulating leaves on the border of the road, controlled with falloff and inverted curve, so far so good, as in screenshot 1 (see attached);  but when I put on top of these an additional paint area to exclude even more leaves, it`s not working as expected; the paint area exclude the leaves, but around the exluded area mores leaves appeared (see attached 2).
How is the correct workflow to do this?

thank you

Rokas

  • iToo Software
  • Hero Member
  • *****
  • Posts: 1429
    • iToo
Re: Fallof affect surface + paint area
« Reply #1 on: December 21, 2018, 08:30:16 AM »
Hi

we need to see Your setup to give a personalized solution.

Works fine with this setup:
Rokas
iToo Software