Hi All,
I am trying to setup a chair and table system for a restaurant project.
I will depict the steps that i followed.
I imported a chair model, converted it into corona proxy, made 4 instances of it, rotated them at 90 degrees from the center and grouped them.
Then i created a Forest set and included that group in that set.
Then i created a line, created FFP, included spline as a path distribution mode and selected Forest set as geometry.
It shows the distribution as boxes in the viewport but in render it is blank.
Is this a problem from my end, am I doing something wrong or is such a setup not supported yet with FPP.
Attaching the screen shot and the 3dsmax file.
Software used : 3dsmax 2020, FPP 8.2.2, Corona 10 RC1