Itoo Software Forum

Author Topic: Request: Scale X/Y  (Read 2806 times)


  • Full Member
  • ***
  • Posts: 122
Request: Scale X/Y
« on: April 28, 2011, 08:11:11 AM »
And not just width. I made this in CityEngine. The distribution map was done by mapping a radial gradient, the Orientation was done by using the plot orientation to a gray value, and the scaleX and scaleY maps were done in a similar way (plot sx to drive grey, plot sy to drive grey). I'd therefore like to use them to fit a distribution object to the Plots. In the provided maps, the min scale is 100% / 1m and the max is 4000% / 40m. Orientation drives the Z rotation.


  • Administrator
  • Hero Member
  • *****
  • Posts: 3736
    • iToo Software
Re: Request: Scale X/Y
« Reply #1 on: April 28, 2011, 06:03:50 PM »

Ok, i add your suggestion to the wishlist. I guess we would change the width/height parameters to a X/Y/Z scheme, but we must check the compatibility with existing scenes.

Carlos Quintero
iToo Software