Itoo Software Forum

Author Topic: Clone  (Read 3777 times)

glorybound

  • Newbie
  • *
  • Posts: 14
Clone
« on: March 24, 2008, 03:21:02 PM »
Howdy,

I am trying to use the clone.  How would I go about cloning a section of a fence alone a closed spline?  I see on the free plug-in page this is being done.  Any help would be greatly appreciated.

Thanks,
Bobby W Parker
http://www.whitebirchstudios.com

iToo

  • Administrator
  • Hero Member
  • *****
  • Posts: 3076
    • iToo Software
Re: Clone
« Reply #1 on: March 25, 2008, 04:14:52 PM »
Hi,

You must Clone the fence section, and use a path deform modifier to conform it over the spline.

Carlos Quintero
iToo Software