Itoo Software Forum

Author Topic: clipping a complex rooftop  (Read 730 times)

Mitko

  • Newbie
  • *
  • Posts: 3
clipping a complex rooftop
« on: June 14, 2019, 11:28:13 AM »
Hi everyone. I have this rooftop. How can I create also side tiles in the base of the roof?

Rokas

  • iToo Software
  • Hero Member
  • *****
  • Posts: 1913
    • iToo
Re: clipping a complex rooftop
« Reply #1 on: June 14, 2019, 03:14:40 PM »
In this case You can use "Cap Holes" modifier. In future RC versions there is plan for Capping sliced segments within RC object itself so the instancing engine remains intact.
Rokas
iToo Software

Mitko

  • Newbie
  • *
  • Posts: 3
Re: clipping a complex rooftop
« Reply #2 on: June 14, 2019, 03:19:26 PM »
ok, But I would like to have the finished design on the sides like the tiles on the top left side of the image, not just capped. Is it possible?

Mitko

  • Newbie
  • *
  • Posts: 3
Re: clipping a complex rooftop
« Reply #3 on: June 14, 2019, 03:23:53 PM »
More like on the image, placed where the arrows are.