Hi, I'm trying to add a segment to the start and end of a spline section, with a specific material ID. I tried with adding it on vertex corners with a conditional, but this doens't always work, because something RC thinks it still is the previous ID and omits the segment.
I also like to add a segment sometimes on a vertex corner within that specific ID when, it's a 90° or more angle.
I tried this (and the previous problem) with markers on the same spline. But when I use, snap to vertex (to the underlying spline with different IDs) to add it and change the ID of the marker, I run into the following problems:
-Sometimes it's 45° rotated (or some very weird rotation) sometimes not. Even when it is on a corner that just divides a straight line.
-Sometimes if I change the ID of the marker, the segment simply doesn't change to the desired segment.
This can be solved if I move the marker a little bit. So it seems that markers that share the same position (but not even exactly the same position) of a underlying vertex (with or without ID changes from one section to the other), have some weird issues.
Could this be related to being 'far away' from the origin? I tried moving it closer the origin but it doesn't change anything. These are big buildings and I'm drawing in cm.