Itoo Software Forum

Author Topic: Array 2s Default segment Adaptive mode  (Read 855 times)

dejan

  • Newbie
  • *
  • Posts: 5
Array 2s Default segment Adaptive mode
« on: September 17, 2021, 09:47:09 AM »
Hi, I'm trying to create a simple glass brick wall array. I have a clipping area spline and a glass brick segment wired to the Default in the array. The deafault segment mode is set to adaptive but it is only adaptive on the X axis and on the Y axis it is simply slicing the bricks. How can I set it to be adaptive on both axes?

Paul Roberts

  • iToo Software
  • Hero Member
  • *****
  • Posts: 1990
Re: Array 2s Default segment Adaptive mode
« Reply #1 on: September 17, 2021, 09:56:16 AM »
Hi,

Thanks for the question. Although the Generator doesn't offer this option, there is a Macro that you can use to add adaptive scaling on the Y Axis.



I hope that helps,

Paul
Paul Roberts
iToo Software

dejan

  • Newbie
  • *
  • Posts: 5
Re: Array 2s Default segment Adaptive mode
« Reply #2 on: September 17, 2021, 10:03:03 AM »
That did it. Still learning...  :D
Thank you Paul!