Hi Evgeniy,
I apologize for the problems, but of course there was not any intention of ignoring you, regardless if you maintenance plan is active or not.
As Rokas replied above, this issue was already registered in our to-do list for checking.
But please note that actually we have more than 200 pending issues for RailClone, including bugs, features and improvements.
The resolution time for each one may go from hours to days, depending of their complexity. Also, once a bug is fixed, it may take some time until a new build is ready to be released.
I just checked this specific issue, but unfortunately i cannot find any way to fix it.
The "Fillet" process creates new bezier-corners and remove the existing ones. More than a bug, this issue should be classified as an incompatibility between features.
I tried an alternative procedure, which i hope it works for you. In this way:
- Instead to define the "corners" using the type of vertex, i used a Conditional node with Material = 2.
- I set the Material ID to 2 for each spline segment BEFORE the vertex, where i want to insert a corner piece.
Aditionally i made these changes, to solve other issues:
- "Rotation X" is removed from the Generator, and applied to the Segments (i find more intuitive to control the rotation in this way).
- Segment->"Y Alignment" is changed from "Pivot" to "Automatic". This was necessary to center the corner pieces on the spline, and bend them correctly.
You can find attached the modified scene. I hope that helps.