Itoo Software Forum

Author Topic: boundary spline problems  (Read 1465 times)

polynominal

  • Newbie
  • *
  • Posts: 3
boundary spline problems
« on: November 15, 2018, 10:21:44 PM »
Hello guys!
I'm doing a floor parquet and i use the preset library to create it.

1. i create the spline from surface border (create shape from selection)
2. reset xform
3. apply it to railclone

But it gives me a bad geometry in some places like in the screenshot  (I've created a spline from scratch and it wont have any issues, the problem is when i have to extract spline from surfaces)

How am i supposed to extract splines from surfaces so that railclone wont have problems ?
u can see the 3ds max file

Rokas

  • Hero Member
  • *****
  • Posts: 3324
Re: boundary spline problems
« Reply #1 on: November 16, 2018, 07:18:51 AM »
It is infamous boolean function. It sometimes misbehaves if using inappropriate measuring units. I always use cm/cm setting with good results.


Opening Your scene and converting Your scene to my units opens scene fine.
Rokas

polynominal

  • Newbie
  • *
  • Posts: 3
Re: boundary spline problems
« Reply #2 on: November 16, 2018, 02:24:14 PM »
 :) thank u very much !