Itoo Software Forum

« previous next »
Pages: [1]

Author Topic: Complex rooftop  (Read 714 times)

PR4682

  • Newbie
  • *
  • Posts: 8
Complex rooftop
« on: June 19, 2019, 10:01:18 AM »
Hi everyone. Is it possible to be achieved a result similar to the one shown in the image?
Red Arrows are indicating where I need to place a tile with a side finish.
Thank you in advance for any support!
Logged

Rokas

  • Hero Member
  • *****
  • Posts: 3324
Re: Complex rooftop
« Reply #1 on: June 19, 2019, 11:57:47 AM »
You can try to make a side finish with separate Linear RailClone Array and setting to apply it only on some material ID of the spline.
Logged
Rokas

PR4682

  • Newbie
  • *
  • Posts: 8
Re: Complex rooftop
« Reply #2 on: June 19, 2019, 02:12:28 PM »
But they will overlap each other causing defects in the render, right?
Logged

Rokas

  • Hero Member
  • *****
  • Posts: 3324
Re: Complex rooftop
« Reply #3 on: June 19, 2019, 02:31:37 PM »
Likely it wont be suitable for close-up render
Logged
Rokas

PR4682

  • Newbie
  • *
  • Posts: 8
Re: Complex rooftop
« Reply #4 on: June 20, 2019, 09:09:57 AM »
What would be a good solution in the case where we have a close shot?
Logged

Rokas

  • Hero Member
  • *****
  • Posts: 3324
Re: Complex rooftop
« Reply #5 on: June 20, 2019, 09:55:08 AM »
You could create two splines- one for side tiles and one for main tiles. They can have different sizes. Then use Lonear Array to place Your Perimeter tiles.
You will need to play with Perimterer tiles to align correctly for Your shot.

Logged
Rokas
Pages: [1]
« previous next »