Itoo Software Forum

Author Topic: Gaps in RC objects when using bevel  (Read 225 times)

mike.kominek

  • Newbie
  • *
  • Posts: 23
Gaps in RC objects when using bevel
« on: May 30, 2019, 09:50:44 AM »
When using bevel to make sure there is an edge for every spline vertex, RC for some reason creates gaps in generated mesh for parts of the mesh where the spline is perfectly straight (or similar cause I did not manage to diagnose).
It does react to changing interpolation and "optimize" within the spline settings but not to any usable results.




Rokas

  • iToo Software
  • Hero Member
  • *****
  • Posts: 1749
    • iToo
Re: Gaps in RC objects when using bevel
« Reply #1 on: May 30, 2019, 10:26:34 AM »
why do You use bevel and not adaptive mode ?
Rokas
iToo Software

mike.kominek

  • Newbie
  • *
  • Posts: 23
Re: Gaps in RC objects when using bevel
« Reply #2 on: May 30, 2019, 10:29:41 AM »
Because my segment has a 3d shape to it that I need to maintain. Just not shown in the example

Rokas

  • iToo Software
  • Hero Member
  • *****
  • Posts: 1749
    • iToo
Re: Gaps in RC objects when using bevel
« Reply #3 on: May 30, 2019, 01:18:00 PM »
Please attach your geometry file and describe what You are building. Only knowing what You are trying to do we can help You.
Rokas
iToo Software

mike.kominek

  • Newbie
  • *
  • Posts: 23
Re: Gaps in RC objects when using bevel
« Reply #4 on: June 04, 2019, 11:12:17 AM »
Hi Rokas,

the issue appears to have fixed itself as i was progressing so not to worry about for now.

Thanks