Itoo Software Forum

Author Topic: Herringbone from Multiple Segments  (Read 247 times)

M55

  • Newbie
  • *
  • Posts: 39
Herringbone from Multiple Segments
« on: October 26, 2018, 12:55:51 PM »
i have made some herringbone pavements with 2 segments. getting variation through a material node. that works fine.

now i would like to do a herringbone pavement with some more segments (slates) with different materials and the segments should have a vray displacement Mod on it

is that possible?

A more than 2 segments ... tried everything without success
B. vray displacement mod on each segment... tried everything without success

thanks in advance

Rokas

  • iToo Software
  • Hero Member
  • *****
  • Posts: 1407
    • iToo
Re: Herringbone from Multiple Segments
« Reply #1 on: October 26, 2018, 01:17:30 PM »
A more than 2 segments ... tried everything without success
B. vray displacement mod on each segment... tried everything without success

A. It should be no problem at all.
"More segments"- should add benefit of new geometry. Use Randomize node to randomize then.
To Randomize material - no new segments should be added. Use Material node tor randomize material.

B. That is not possible. RailClone uses segments geometry- they You see it in the viewport as building blocks.
Rokas
iToo Software

M55

  • Newbie
  • *
  • Posts: 39
Re: Herringbone from Multiple Segments
« Reply #2 on: October 29, 2018, 10:09:10 AM »
Thanks Rokas,

silly mistake ... used wrong cloned segments for creation ... now everything works fine.

Good to know about the vray displacement mod ... but no problem.

Thanks for fast response

Klaus