Making a wall of bricks with a specific brick that needs to be on the starts and ends of wall corners, window reveals etc.
attached is how it is currently looking with the layout and current geo images.
I tried changing the splines. Rather than use clipping spline for window reveals, making the splines into sections of the wall so that it knows where the start and end is. this works for adding the correct angled piece at the start and end but the full rectangle pieces inbetween end up being cut rather small in places and in fact I would rather the end pieces be the ones getting sliced short.
Is there a way to adjust this so that it roughly keep the middle full segments between like 70-100% of its size and then the start and end just slot in to make sure the edges have the angled piece?
hope that makes sense!