Outgoing / Incoming corners ?

[HU0164]

Hi,
I'd like to be able to put an object called A on the outgoing corners and an object called B (or no object) on the incoming corners.
Is this possible?

[Michal Karmazín]

Hi,

You can place the correct object using the Vertex Angle option within the Conditional Operator. I hope that helps.

Best regards,

[HU0164]

Thank you, it works.

And if I want to put an object only in the outgoing corners and nothing in the incoming corners.
In the incoming corners, I'd like the "default node" to be used.
Is this possible?

[Michal Karmazín]

Depending on whether the beveling operation is required, you can either wire an empty Segment or change the type of the relevant vertices and adjust the Rules > Corner > Vertex Type setting accordingly.

Best regards,

[HU0164]

Thank's.

I've pretty much succeeded in what I set out to do.
But I don't understand why the 2 elements designated by the arrows don't take into account (on this side of my angle object) the padding value.
Everything else works fine.
Thanks for your help.

[Michal Karmazín]

You're welcome. The alignment issue occurs because the Pivot Point is used to position the segment. However, you can easily correct this by adjusting the Right Padding value to compensate. Please find attached a revised version of your scene. I hope this helps.

Best regards,