Itoo Software Forum

Author Topic: Pillars/colums  (Read 114 times)

enzo_87

  • Newbie
  • *
  • Posts: 31
    • www.lorenzospinola.com
Pillars/colums
« on: March 24, 2020, 02:17:16 PM »
Good afternoon everyone.
sorry to bother because of my lack in experience using railclone.

I might need some suggestions/tips...
I'm trying to automate a process for making some structural pillars, I manage to create the pillars itself, but I'm struggling to connect the base to it at the moment.
or actually, I'd like that it stays horizontal. (like the little example in the corner of the image)

Is there any way to make this?
attached also the file if needed to understand better.

Thanks in advance

Rokas

  • iToo Software
  • Hero Member
  • *****
  • Posts: 2514
    • iToo
Re: Pillars/colums
« Reply #1 on: March 24, 2020, 04:20:50 PM »
Hi
Thank You for attaching file. To fix this style, I have just set base to be stepped:


and played with other segments alignment- setting them to Pivot.
Hope this helps.
Rokas
iToo Software

enzo_87

  • Newbie
  • *
  • Posts: 31
    • www.lorenzospinola.com
Re: Pillars/colums
« Reply #2 on: March 24, 2020, 04:22:40 PM »
thank you very much.
silly me!
I should have think about that soone, like a stairs, thanks so much