Itoo Software Forum

Author Topic: Simple cladding problem  (Read 422 times)


  • Newbie
  • *
  • Posts: 1
Simple cladding problem
« on: September 28, 2022, 04:17:29 PM »
I am trying to do a simple metal cladding facade with Railclone,
I've started by a cladding templates (concrete cladding) it work well,
but  my last segments are scaled, how to avoid it?
(I need them to be at the same size)

Sorry for my bad english,

« Last Edit: September 28, 2022, 04:24:17 PM by OI3972 »

Michal Karmazín

  • iToo Software
  • Hero Member
  • *****
  • Posts: 2111
Re: Simple cladding problem
« Reply #1 on: September 30, 2022, 10:29:42 AM »

Well, the mentioned style uses the “Scale final segmentmacro. If you prefer to “slightly scale all these to fit”, you should be using the Adaptive Mode for the Default Segment instead.

The adaptive mode calculates the number of whole segments that would fit along a spline segment and then scales them on the X axis to fill the available space. This mode generates complete segments, with no clipping at the start or end of a spline segment.

I hope that helps.

Best regards,