Itoo Software Forum

Author Topic: Spline and Surface add  (Read 757 times)


  • Newbie
  • *
  • Posts: 15
Spline and Surface add
« on: January 27, 2017, 11:27:11 AM »
Is there any way for combing two surfaces/spline in Forestpack. (Without attaching) It is difficult for me to explain this in english perhaps my Photshop screenshot and the example image can explain it very fast.

Sometimes I have different surfaces where I want to put for an example the "Bicycle Parking" from the Railclone Library. I dont want to attached these surfaces because of many reasons.

Perhaps some can help me. If it is not possible this would be an feature request from me :-)


Michal Karmazín

  • iToo Software
  • Hero Member
  • *****
  • Posts: 1768
Re: Spline and Surface add
« Reply #1 on: January 27, 2017, 01:02:05 PM »

Currently isn't possible to use multiple Splines / Surfaces within one Generator, but it's possible to use multiple Generators within one style, so you can archive it by copying the Generator and wiring the other Spline / Surface into it.

Best regards,