Itoo Software Forum

Author Topic: Stopping an END or START segment at spline ID change  (Read 95 times)

antmx

  • Newbie
  • *
  • Posts: 1
Stopping an END or START segment at spline ID change
« on: August 08, 2019, 12:35:48 PM »
I have a style with an end and start segment, but now I want to change my spline ID to make a different style on the same spline, but the end segment is in the way.  Hopefully the image below describes it. 

I can use a conditional operator and change each spline section to curve or line and wire in a null segment, but this isn't really what I want as a solution.

Is there an elegant or simple way around this.



Rokas

  • iToo Software
  • Hero Member
  • *****
  • Posts: 1749
    • iToo
Re: Stopping an END or START segment at spline ID change
« Reply #1 on: August 08, 2019, 01:32:55 PM »
I can use a conditional operator and change each spline section to curve or line and wire in a null segment, but this isn't really what I want as a solution.

That seems like a reasonable solution. When using limit to Material ID, imagine different Material ID as separate splines.
Rokas
iToo Software