Hey everyone, I'm using one of RC's default templates (The Concrete Curb) from their library, and I'm encountering two issues.
1) I'm utilizing the Set ID feature to switch between the standard curb and the section where it lowers to ground level. I set the spline segments. Set ID to "2" for the areas of the spline in which I want to be lower. It works as expected, but the rounded corners don't align with the curb and the rest of the standard curve. See the attached image - "Img_001a". The only solution I found that worked was extending the length of the segments assigned to "2" further up the straighter part of the spline. (See Attached - "Img_001b. "). Is there another way or setting I need to adjust to fix this? Because if I need the curb to ramp down right at the start of the rounded corner, I'm a bit SOL.
2) I want to shorten the ramp part of the curb (002a), but no matter how I go about it, it keeps a gap (002b). I've tried swapping out the mesh with the same one but shorter and it still does it (even after I reset the transforms). In the RC style editor, I've tried adjusting the segment object's Scale and the fixed size. I also tried utilizing a transform node but still get the same results. I thought it might have been fixed with padding, but when I adjust that, nothing happens. So I'm not sure how to fix this issue much at all.
All help/advice is greatly appreciated!
- Ken
Topic: Two Railclone issues I'm having (Read 1235 times)
