Itoo Software Forum

« previous next »
Pages: [1]

Author Topic: Spline offset + Filter By Mat.ID  (Read 1073 times)

Dragan

  • Hero Member
  • *****
  • Posts: 1464
Spline offset + Filter By Mat.ID
« on: February 16, 2025, 02:42:10 PM »
Something wrong when nodes are set as:  Offset -> Filter
It seems to be working fine when nodes are set as: Filter -> Offset


Logged

iToo

  • Administrator
  • Hero Member
  • *****
  • Posts: 4646
    • iToo Software
Re: Spline offset + Filter By Mat.ID
« Reply #1 on: February 17, 2025, 10:07:55 AM »
Same case as Boolean. Offset operator generates new splines, altering Mat.ID in the process.
I will check if it's possible to improve that, at least with the '3D mode', which is less destructive.
Logged
Carlos Quintero
iToo Software
Pages: [1]
« previous next »